SSD1306_SWITCHCAPVCC = generate display voltage from 3. Static const unsigned char PROGMEM logo_bmp = #define NUMFLAKES 10 // Number of snowflakes in the animation example #define OLED_RESET -1 // Reset pin # (or -1 if sharing Arduino reset pin)Īdafruit_SSD1306 display(SCREEN_WIDTH, SCREEN_HEIGHT, &Wire, OLED_RESET) Declaration for an SSD1306 display connected to I2C (SDA, SCL pins) #define SCREEN_HEIGHT 64 // OLED display height, in pixels #define SCREEN_WIDTH 128 // OLED display width, in pixels BSD license, check license.txt for more information All text above, and the splash screen below must be included in any redistribution.
Written by Limor Fried/Ladyada for Adafruit Industries, with contributions from the open source community. This example is for a 128x32 pixel display using I2C to communicate 3 pins are required to interface (two I2C and one reset).Īdafruit invests time and resources providing this open source code, please support Adafruit and open-source hardware by purchasing products from Adafruit! Pick one up today in the adafruit shop! -> Extra on-board peripherals: The UNO R4 Minima introduces a range of on-board peripherals, including a 12-bit DAC, CAN BUS, and OP AMP. This is an example for our Monochrome OLEDs based on SSD1306 drivers. The following code should load: /*********
